From breadboard to protoshield

Tests on both the light and sound circuits on breadboard were promising. They tests did show a great deal of false triggering and I believe this was due to the bad connection nature of breadboards.

I took both circuits and layed them out on protoboard. This allows direct connection to the Arduino.

Tests so far are very promising.

soundTrigger circuit with microphone in the background

stormTrigger V3 layed out and working well

soundTrigger rising

Playing with an electret microphone and a simple circuit.
A Mega328 samples the noise generated by the circuit and triggers a camera on the output via an opto-isolator.

Schematic in Eagle

Bread boarded Prototype

Measuring I/O performance

Performance looks promising. Measuring a triggering delay of 35uS (microseconds).
Arduino sketch to follow...

New light detector circuit

Prototyping the new light circuit on breadboard. Everything is working well so far.

Circuit detail (Transistor is wrong type but the correct footprint for the PCB)

Output in dim light is about 0.13V going up to just over 1V with an inspection lamp close to the transistor.

Photo Transistor

Low Power Op-Amp

This circuit will form the second PCB in a two stack design. Interconnects will be via pin headers (0.1") and power will be from a CR2032 3V coin cell battery.

The prototype PCB will be mostly SMD tech with the photo transistor and pin headers being through-hole.

Bit of code that just works...

/*
StormTrigger V3 30-07-2013
 */
#define FASTADC 1
// defines for setting and clearing register bits
#ifndef cbi
#define cbi(sfr, bit) (_SFR_BYTE(sfr) &= ~_BV(bit))
#endif
#ifndef sbi
#define sbi(sfr, bit) (_SFR_BYTE(sfr) |= _BV(bit))
#endif

#define LIGHT 0
#define OUT_FOCUS 2
#define OUT_SHUTTER 3
#define LED 13
int trigVal = 0;

void setup() {

#if FASTADC
  // set prescale to 16
  sbi(ADCSRA,ADPS2) ;
  cbi(ADCSRA,ADPS1) ;
  sbi(ADCSRA,ADPS0) ;
#endif
  pinMode(OUT_FOCUS, OUTPUT);
  pinMode(OUT_SHUTTER, OUTPUT);
  pinMode(LED, OUTPUT);
  PORTD = B01010000;
  // calibrate sensor to just above ambient reading
  int ambVal = analogRead(LIGHT);
  trigVal = ambVal + 40;
}
void loop() {
  //read light level
  int lightVal = analogRead(LIGHT);
  //compare light reading to trigger value
  if (lightVal >= trigVal)
  {
    //trigger camera
    PORTD = B00101100;
    delay(15);
    PORTD = B01010000;
    digitalWrite(LED, HIGH);
    delay(30);
    digitalWrite(LED, LOW);
  }

}

Version 3 - New Design

Hotshoe mounted
Built-in sensor
Coincell battery operation
Single LED feedback
Automatic setting & operation

35mm x 25mm x 15mm volume to work within.

Shown is the enclosure mounted on 7D.

Stacked PCBs. One uC PCB and one I/O PCB with a board interconnect.